Dell OptiPlex GX200 - Manual (Page 47)

To remove a hard-disk drive from the mini tower's internal hard-disk drive bracket, perform the following steps.
1. If you are replacing a hard-disk drive that contains data you want to keep, make a backup copy of your files before you continue this
procedure.
2. Remove the computer cover .
3. Remove the front bezel .
4. Open the drive bracket from the chassis:
a. Disconnect the DC power cable and EIDE cable from the drive.
b. Remove the screw securing the hard-disk drive bracket to the chassis.
c. Grasp the bracket, and rotate it outward from the chassis until the sliding tab clears the slide rail on the chassis (see Figure 16 ).
d. Lift the bracket up slightly to free its hinge tabs from the chassis hinge slots.
5. Remove the bracket from the chassis.
Figure 17. Hard-Disk Drive Removal From Bracket
6. Remove the four screws that hold the drive in the bracket (see Figure 17 ).
Retain the screws for use with the replacement hard-disk drive.
7. Remove the drive by sliding it out of the bracket.
Hard-Disk Drive Replacement
To install a replacement hard-disk drive, perform the following steps.
1 Drive bracket slide rail
2 Chassis hinge slots
3 Hinge tabs
4 Sliding tab
5 Drive bracket
CAUTION: To avoid the possibility of electric shock, turn off the computer and any peripherals, disconnect them from
electrical outlets, and then wait at least 5 seconds before you remove the computer cover. Also, before you remove a drive,
see the other precautions in "
Precautionary Measures ."
1 Screws (4)
2 Sliding tab
3 Drive bracket
4 1.6-inch drive