Introduction, Figure 1: md3000i as a backup target, Prerequisites – Dell PowerVault DL2100 User Manual
Page 6
Configuring the Dell™ PowerVault™ MD3000i Array as a Backup Target for CommVault™ Simpana™
Page 3
Introduction
This document explains how to configure a Dell™ PowerVault™ MD3000i Array as a backup target for the
DL Backup to Disk Appliance functioning as a CommVault™ Simpana™ Media Agent. (Refer to figure 1)
NOTE: If one or more protected servers and the DL Backup to Disk Appliance share a PowerVault
MD3000i Array, ensure the DL Backup to Disk Appliance backup target virtual disks reside on separate
disk groups from those of the protected servers.
Figure 1: MD3000i as a backup Target
Prerequisites
This paper assumes that the DL Backup to Disk Appliance has been configured and the desired virtual
disks on the PowerVault™ MD3000i Array are created and made available to the DL Backup to Disk
Appliance by a SAN Administrator. It also assumes the PowerVault™ MD3000i Array Modular Disk Storage
Manager (MDSM) has been installed on a system other than the DL Backup to Disk Appliance.
The following table lists the minimum software versions required to support a PowerVault™ MD3000i
Array as a backup target. The PowerVault™ MD3000i Array resources are available on the Customer
Support site at
by selecting PowerVault™ MD3000i Array as your product model under
Manuals and Drivers and Downloads.