Dell Inspiron 660 (Early 2012) - Manual (Page 23)

Memory Module(s)
23
CAUTION:
To avoid damage to the memory module, press the memory module
straight down into the connector while you apply equal force to each end of the
memory module.
3 Insert the memory module into the memory-module connector until the
memory module snaps into position and the securing clip locks in place.
If you insert the memory module correctly, the securing clips snap into the
cutouts at each end of the memory module.
Postrequisites
1 Replace the computer cover. See "Replacing the Computer Cover" on
page 19.
2 Follow the instructions in "After Working Inside Your Computer" on
page 11.
3 Connect your computer and devices to electrical outlets, and then turn
them on.
If a message appears stating that the memory size has changed,
press <F1> to continue.
Log on to your computer. To verify that the memory is installed correctly,
click Start
→ Control Panel→ System. Check the amount of
memory (RAM) listed.
1 cutouts (2) 2 securing clips (2) (snapped in position)
2
1
book.book Page 23 Tuesday, April 17, 2012 11:37 AM