Dell Inspiron 660 (Early 2012) - Manual (Page 85)

System Board
85
System Board
WARNING:
Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 9. For additional safety best practices information, see the Regulatory
Compliance Homepage at dell.com/regulatory_compliance.
Removing the System Board
Prerequisites
1 Remove the computer cover. See "Removing the Computer Cover" on
page 18.
2 Remove the Mini-Card, if applicable. See "Removing the Mini-Card" on
page 40.
3 Remove the any PCI-Express cards, if applicable. See "Removing PCI
Express Cards" on page 33.
4 Remove the processor fan and heat-sink assembly. See "Removing the
Processor Fan and Heat-Sink Assembly" on page 69.
5 Remove the processor. See "Removing the Processor" on page 73.
6 Remove the memory modules. See "Removing the Memory Module(s)" on
page 21. Record which memory module is removed from each DIMM slot
so that the memory modules can be installed in the same slot after the
system board is replaced.
book.book Page 85 Tuesday, April 17, 2012 11:37 AM