Dell PowerVault MD3000i - Manual (Page 107)

Script Commands
107
• When you specify physical disk locations by using enclosure ID values and
slot ID values, separate the ID values with a comma. If you enter more
than one set of ID values, separate each set of values by a space. Put
parentheses around the set of values. For example:
(0,0 0,1 0,2 0,3 1,0 1,1 1,2 1,3)
• Italicized terms in the command indicate a value or information that you
need to provide. For example, when you encounter the italicized term:
numberOfPhysicalDisks
replace the italicized term with a value for the number of physical disks
that you want to include with the command.
• You can use any combination of alphanumeric characters, hyphens, and
underscores for the names of the following components:
– Storage arrays
– Host groups
– Hosts
– Disk groups
– Virtual disks
– Host bus adapter (HBA) host ports
Names can have a maximum of 30 characters. If the label contains
multiple words, underscores, or hyphens, you must put quotation
marks around the name. In some usages you must also put brackets
around the name. The description of each parameter tells you if you
must put quotation marks or brackets around a parameter value. The
character string cannot contain a new line. You must use unique
names or the RAID controller module firmware returns an error.
NOTE:
You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
On Microsoft
®
Windows
®
, you must put a backslash (\) before and
after the name in addition to other delimiters. For example, the