Dell PowerVault MD3000i - Manual (Page 202)

202
Script Commands
NOTE:
When using this command, you can specify one or more of the parameters.
You do not, however, need to use all of the parameters.
NOTE:
You can apply the addCapacity, segmentSize, userLabel, and
logicalUnitNumber parameters to only one virtual disk at a time.
NOTE:
Setting the addCapacity, addPhysicalDisks, or segmentSize parameter
starts a long-running operation that you cannot stop. These long-running
operations are performed in the background and do not prevent you from running
other commands. To display the progress of long-running operations, use the show
virtualDisk actionProgress command.
segmentSize Amount of data (in kilobytes) that the RAID controller
module writes on a single physical disk in a virtual disk
before writing data on the next physical disk. Valid
values are 8, 16, 32, 64, 128, 256, or 512. For
information about the segmentSize parameter, see
"Using the Auto Configure Command" on page 53.
userLabel Specifies the new name to give an existing virtual disk.
You must put quotation marks (" ") around the new
virtual disk name.
accessVirtualDisk Specifies the logical unit number for the access virtual
disk. The logical unit number is the only property that
you can set for the access virtual disk.
NOTE:
If you specify the accessVirtualDisk parameter,
the only property that you can set is the
logicalUnitNumber
.
logicalUnitNumber Defines specific virtual disk-to-LUN mappings to an
individual host or assigns the host to a host group.
host Specifies the name of the host to which the virtual disk
is mapped. You must put quotation marks (" ") around
the host name.
hostGroup Specifies the name of the host group to which the
virtual disk is mapped. You must put quotation marks
(" ") around the host group name.
Parameter Description