Dell PowerVault MD3000i - Manual (Page 157)

Script Commands
157
warningThresholdPercent= percentValue
repositoryFullPolicy=(failSourceWrites |
failSnapShot)]
Parameters
NOTE:
You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
Parameter Description
virtualDisk or virtualDisks Name of the specific virtual disk for which to start a
fresh copy-on-write operation. You can enter more
than one virtual disk name. You must put
brackets ([ ]) around the virtual disk name. If the
virtual disk name has special characters, you
must also put quotation marks (" ") around the
virtual disk name.
userLabel Name of the snapshot virtual disk. You must put
quotation marks (" ") around the snapshot virtual
disk name. If you enter more than one snapshot
virtual disk name, this command fails.
warningThresholdPercent Percentage of repository capacity at which you
receive a warning that the repository is nearing
full. Use integer values. For example, a value of
70 means 70 percent. The default value is
50 percent.
NOTE:
If warningThresholdPercent is not
specified, the previously set value is used.
repositoryFullPolicy Specifies how snapshot processing continues if
the repository is full. You can choose to fail writes
to the source virtual disk (failSourceWrites) or
fail writes to the snapshot virtual disk
(failSnapShot). The default value is
failSnapShot.
NOTE:
If repositoryFullPolicy is not specified, the
previously set value is used.