Dell PowerVault MD3000i - Manual (Page 171)

Script Commands
171
( nvsramByteSetting | nvsramBitSetting ) |
iscsiHostPort [(1 | 2)] = iscsi-host-port-options
rloginEnabled=(TRUE | FALSE)
Parameters
Parameter Description
controller This parameter is the RAID controller module for which
you want to define properties. Valid identifiers for the
RAID controller module are 0 or 1, where 0 is the RAID
controller module on the left and 1 is the RAID controller
module on the right when viewed from the rear of the
RAID enclosure. You must put square brackets ([ ]) around
the identifier for the RAID controller module. If you do
not specify a RAID controller module, the firmware for the
RAID controller module returns a syntax error.
availability This parameter sets the mode for the RAID controller
module to online, offline, or serviceMode.
ethernetPort This parameter defines the attributes (options) for the
management Ethernet ports. Refer to Table 2-4 for a list of
the attributes that you can set.
Valid Ethernet port identifiers are 1 or 2. You must put
square brackets ([ ]) around the Ethernet port identifier.
globalNVSRAMByte This parameter modifies a portion of the RAID controller
module NVSRAM. Specify the region to be modified using
the starting byte offset within the region, and the size and
value of the new data to be stored into NVSRAM.
hostNVSRAMByte This parameter updates the NVSRAM for the host specific
region. Specifies the host index for the specific host, the
starting offset within the region, the number of bytes, and
the values to be written.
iscsiHostPort This parameter defines the attributes (options) for the
host Ethernet ports. Refer to Table 2-5 for a list of the
attributes that you can set.
Valid Ethernet port identifiers are 1 or 2. You must put
square brackets ([ ]) around the Ethernet port identifier.