Dell PowerVault MD3000i - Manual (Page 184)

184
Script Commands
globalNVSRAMByte [ nvsramOffset ]=
( nvsramByteSetting |
nvsramBitSetting ) | hostNVSRAMByte [ hostType ,
nvsramOffset ]=( nvsramByteSetting |
nvsramBitSetting ) |
iscsiHostPort [(1 | 2)]= iscsiHostPortOptions
rloginEnabled=(TRUE
| FALSE) | serviceAllowedIndicator=(on | off)
Parameters
Parameter Description
controller The RAID controller module for which you want to
define properties. Valid identifiers for the RAID
controller module are 0 or 1, where 0 is the RAID
controller module on the left, and 1 is the RAID
controller module on the right when viewed from the
rear of the enclosure. Enclose the identifier for the RAID
controller module in square brackets ([ ]). If you do not
specify a RAID controller module, the firmware for the
RAID controller module returns a syntax error.
availability The mode for the RAID controller module, which you
can set to online, offline, or serviceMode (service).
ethernetPort The attributes (options) for the management Ethernet
ports. The entries to support this parameter are listed in
"Syntax Element Statement Data" on page 185”. Many
settings are possible, including setting the IP address,
the gateway address, and the subnet mask address.
globalNVSRAMByte A portion of the RAID controller module NVSRAM.
Specify the region to be modified using the starting byte
offset within the region, and the size and value of the
new data to be stored into NVSRAM.
hostNVSRAMByte The NVSRAM for the host-specific region. The setting
specifies the host index for the specific host, the starting
offset within the region, the number of bytes, and the
values to be written.