Optical drive board, Removing the optical drive board, Replacing the optical drive board – Dell Inspiron 1750 (Mid 2009) User Manual
Page 40
Back to Contents Page
Optical Drive Board
Dell™ Inspiron™ 17 Service Manual
Removing the Optical Drive Board
Replacing the Optical Drive Board
Removing the Optical Drive Board
1.
Follow the procedures in
Before You Begin
.
2.
Remove the system board (see
Removing the System Board
).
3.
Turn the system board over and disconnect the optical drive board from the system board connector.
4.
Disconnect the optical drive board from the system board connector.
Replacing the Optical Drive Board
1.
Follow the procedures in
Before You Begin
.
2.
Connect the optical drive board to the system board connector.
3.
Replace the system board (see
Replacing the System Board
).
Back to Contents Page
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
system board
2
optical drive board
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.