Usb module, Removing the usb module – Dell Inspiron 1750 (Mid 2009) User Manual
Page 55
Back to Contents Page
USB Module
Dell™ Inspiron™ 17 Service Manual
Removing the USB Module
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the module cover (see
Removing the Module Cover
).
4.
Remove the memory module(s) (see
Removing the Memory Module(s)
).
5.
Remove the hard drive (see
Removing the Hard Drive
).
6.
Remove the optical drive (see
Removing the Optical Drive
).
7.
Remove the center control cover (see
Removing the Center Control Cover
).
8.
Remove the keyboard (see
Removing the Keyboard
).
9.
Remove the palm rest (see
Removing the Palm Rest
).
10.
Remove the tape to release the USB module cable from the battery extension board.
11.
Disconnect the USB module cable from the system board connector.
12.
Remove the screw that secures the USB module to the computer base.
13.
Make note of the USB module cable routing and remove the USB module cable from the routing guide.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1 USB module cable connector
2 USB module cable routing