Setting up the monitor, Attaching the base, Connecting your monitor – Dell SP2009WFP Monitor User Manual
Page 26: Connecting the blue vga cable
Back to Contents Page
Setting Up the Monitor
Dell™
SP2009W Flat Panel Monitor User's Guide
Attaching the Soundbar (optional)
Wall Mounting (Optional)
Attaching the Base
To attach the base of the stand:
1.
Place the monitor on a flat surface.
2.
Turn the screw to tighten the base.
Connecting Your Monitor
To connect your monitor to the computer:
1.
Turn off your computer and disconnect the power cable.
2.
Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer. Do not use both cables on the same computer.
Use both the cables only when they are connected to two different computers with
appropriate video systems.
Connecting the Blue VGA Cable
NOTE: The Base of the stand is detached when the monitor hipped from the factory.
CAUTION:
Before you begin any of the procedures in this section, follow the
Safety Instructions
.