Attaching the soundbar (optional), Removing the stand, Removing the base – Dell SP2009WFP Monitor User Manual
Page 28: Wall mounting (optional), Attaching the soundbar(optional)
After attaching all necessary cables to your monitor and computer, (see
) use the cable management slot to organize all cables as
shown above.
Attaching the Soundbar(optional)
To attach the soundbar:
Removing the Base
To remove the base of the stand::
1.
Place the monitor panel on soft cloth or cushion on a stable flat table.
2.
Turn the thumb screw counter-clockwise to loosen the base.
3.
Remove the base away from the monitor stand.
Wall Mounting (Optional)
Refer to the instructions that come with the base mounting kit. To convert your LCD display from a desk-mounted to a wall-mounted display, do the following:
1.
Verify that the Power button is turned Off, then disconnect the power cord.
NOTICE:
Do not use with any device other than Dell Soundbar.
NOTE:
The soundbar power connector (+12 V DC output) is for the optional Dell Soundbar only.
1.
Working from the back of the monitor, attach Soundbar by aligning the two slots with the two tabs along the bottom of the monitor.
2.
Slide the Soundbar to the left until it snaps into place.
3.
Connect the Soundbar with the DC power connector.
4.
Insert the mini stereo plug from the back of the Soundbar into the computer's audio output jack.
NOTE:
To prevent scratches on the LCD screen while removing the stand,
ensure that the monitor is placed on a clean surface.