Cypress EZ-OTG CY7C67200 - Manual (Page 28)

CY7C67200
Document #: 38-08014 Rev. *G Page 28 of 78
Host n Frame Register [R]
• Host 1 Frame Register 0xC096
• Host 2 Frame Register 0xC0B6
Figure 29. Host n Frame Register
Register Description
The Host n Frame register maintains the next frame number
to be transmitted (current frame number + 1). This value is
updated after each SOF transmission. This register resets to
0x0000 after each CPU write to the Host n SOF/EOP Count
register (Host 1: 0xC092, Host 2: 0xC0B2).
Frame (Bits [10:0])
The Frame field contains the next frame number to be trans-
mitted.
Reserved
All reserved bits must be written as ‘0’.
USB Device Only Registers
There are ten sets of USB Device Only registers. All sets
consist of at least two registers, one for Device Port 1 and one
for Device Port 2. In addition, each Device port has eight
possible endpoints. This gives each endpoint register set eight
registers for each Device Port for a total of 16 registers per set.
The USB Device Only registers are covered in this section and
summarized in
Table 27 .
Device n Endpoint n Control Register [R/W]
• Device n Endpoint 0 Control Register [Device 1: 0x0200 Device 2: 0x0280]
• Device n Endpoint 1 Control Register [Device 1: 0x0210 Device 2: 0x0290]
• Device n Endpoint 2 Control Register [Device 1: 0x0220 Device 2: 0x02A0]
• Device n Endpoint 3 Control Register [Device 1: 0x0230 Device 2: 0x02B0]
• Device n Endpoint 4 Control Register [Device 1: 0x0240 Device 2: 0x02C0]
• Device n Endpoint 5 Control Register [Device 1: 0x0250 Device 2: 0x02D0]
• Device n Endpoint 6 Control Register [Device 1: 0x0260 Device 2: 0x02E0]
• Device n Endpoint 7 Control Register [Device 1: 0x0270 Device 2: 0x02F0]
Bit # 15 14 13 12 11 10 9 8
Field Reserved Frame...
Read/Write - - - - - R R R
Default 0 0 0 0 0 0 0 0
Bit # 7 6 5 4 3 2 1 0
Field ...Frame
Read/Write R R R R R R R R
Default 0 0 0 0 0 0 0 0
Table 27.USB Device Only Registers
Register Name
Address
(Device 1/Device 2)
R/W
Device n Endpoint n Control Register 0x02n0 R/W
Device n Endpoint n Address Register 0x02n2 R/W
Device n Endpoint n Count Register 0x02n4 R/W
Device n Endpoint n Status Register 0x02n6 R/W
Device n Endpoint n Count Result Register 0x02n8 R/W
Device n Interrupt Enable Register 0xC08C/0xC0AC R/W
Device n Address Register 0xC08E/0xC0AE R/W
Device n Status Register 0xC090/0xCB0 R/W
Device n Frame Number Register 0xC092/0xC0B2 R
Device n SOF/EOP Count Register 0xC094/0xC0B4 W
[+] Feedback