Dell Inspiron 4100 - Manual (Page 18)

Palm Rest Inserts
1. Save and close any open files, exit any open programs, and shut down the computer.
2. If the computer is connected (docked) to a docking device, undock it.
3. Keep the display open and tilt the computer back so that you can access the bottom of the computer.
4. Slide and hold the latch release on the right side, and remove any device installed in the module bay.
5. Slide and hold the latch release on the left side, and remove any battery installed in the battery bay.
6. Locate the orange palm-rest removal buttons. Firmly press the buttons with the eraser end of a pencil (or a dull utensil smaller than your finger) to
release the palm rests.
7. Remove the palm rests.
1 top cover display assembly 9 bottom case assembly
2 center control cover 10 memory module cover
3 thermal cooling assembly 11 module bay device
4 hybrid cooling fan 12 main battery
5 microprocessor module 13 hard drive
6 system board 14 left speaker/antenna assembly
7 right speaker/antenna assembly 15 palm rest assembly
8 fan guard 16 keyboard