Dell Inspiron 4100 User Manual
Page 32
5.
Remove the two M2 x 3-mm screws that are located in the hard-drive bay door labeled "circle P."
6.
Turn the computer over, and remove the three M2 x 3-mm screws that secure the palm rest to the bottom case:
a.
Remove the two M2 x 3-mm screws that are located on the back edge of the bottom case, underneath the display assembly.
b.
Remove the M2 x 3-mm screw located underneath the keyboard, on the right side of the bottom case, next to the microprocessor thermal cooling
assembly.
7.
Pull up on the pull-tab that is attached to the palm-rest flex cable connector to remove it from the interface connector on the system board.
1 M2.5 x 12-mm screws (3)
2 M2 x 3-mm screws (2)
3 hard-drive bay door
1 M2 x 3-mm screws (3)
2 palm rest
3 palm-rest flex cable
4 bottom case
5 back center of the palm rest
6 touch pad connector