Dell Inspiron 4100 - Manual (Page 27)

9. Pull up on the pull-tab that is attached to the display-feed flex cable connector to remove the tab from the interface connector on the system board.
10. Lift the display assembly up and out of the bottom case.
NOTICE: When reconnecting the display-feed flex cable connector to the system board, push down on the top left and right ends of the connector.
Pressing on the center of the connector may damage resistors and compromise EMI protection in the computer.
1 M2 x 3-mm screws (2)
1 rubber screw covers (6) 5 M2 x 4-mm screws (5)
2 M2.5 x 5-mm screws (4) 6 display-feed flex cable
3 display bezel 7 flex-cable retention bracket
4 top cover 8 display panel