Module bay devices, Memory module – Dell Inspiron 4100 User Manual
Page 21
11.
Connect the modem cable to the modem.
12.
Align the modem with the screw hole(s) and press the modem into the connector on the system board.
13.
Install the screw(s) to secure the modem to the system board.
14.
Replace the modem cover.
Module Bay Devices
1.
Save and close any open files, exit any open programs, and shut down the computer.
2.
If the computer is connected (docked) to a docking device, undock it.
3.
Close the display and turn the computer over.
4.
Slide and hold the latch release, and pull the device out of the module bay.
5.
To replace, insert the new device into the bay, and push it until you hear a click.
Memory Module
Removing the Memory Module Cover
1.
Turn the computer over, and use a flat-blade screwdriver to release the two captive screws from the memory module cover.
2.
Remove the M2.5 x 12-mm screw labeled "circle K."
3.
Place your finger under the cover at the indentation and lift and slide the cover open.
NOTICE:
The cable connectors are keyed for correct insertion; do not force the connections.
NOTICE:
To prevent damage to devices, place them in a travel case when they are not inserted in the computer. Store devices in a dry, safe place, and
avoid pressing down on them or placing heavy objects on top of them.
NOTICE:
Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: