Dell POWEREDGE M1000E - Manual (Page 106)

88 Dell Converged Enhanced Ethernet Administrator’s Guide
53-1002116-01
Default ACL configuration
9
MAC ACLs are supported on the following interface types:
• Physical interfaces
• Logical interfaces (LAGs)
• VLANs
Default ACL configuration
Table 15 lists the default ACL configuration.
ACL configuration guidelines and restrictions
Follow these ACL configuration guidelines and restrictions when configuring ACLs:
• The order of the rules in an ACL is critical. The first rule that matches the traffic stops further
processing of the frames.
• Standard ACLs and extended ACLs cannot have the same name.
ACL configuration and management
You need to enter either the copy running-config startup-config command or the write memory
command to save your configuration changes to Flash so that they are not lost if there is a system
reload or power outage.
NOTE
To see the minimum configuration required to enable FCoE on the Dell M8428-k switch, refer to
Chapter 3, “Initial FCoE and CEE Configuration” .
Creating a standard MAC ACL and adding rules
NOTE
You can use the resequence command to change all the sequence numbers assigned to the rules
in a MAC ACL. For detailed information, see
“Reordering the sequence numbers in a MAC ACL” on
page 90.
To create a standard MAC ACL and add rules, perform the following steps from Privileged EXEC
mode.
1. Enter the configure terminal command to access global configuration mode.
2. Create a standard MAC ACL and enter ACL configuration mode.
TABLE 15 Default MAC ACL configuration
Parameter Default setting
MAC ACLs By default, no MAC ACLs are configured.