Dell POWEREDGE M1000E - Manual (Page 127)

Dell Converged Enhanced Ethernet Administrator’s Guide 109
53-1002116-01
Converged Enhanced Ethernet map configuration
10
Creating a CEE map
Only a single CEE map is allowed, which is created automatically with the name “default.” You are
not be able to delete or rename this map.
To create a CEE map, perform the following steps from Privileged EXEC mode.
1. Enter global configuration mode.
switch#configure terminal
2. Create a CEE map.
switch(config)#cee-map default
The following example creates a CEE map enter CEE-Map CLI configuration submode.
switch:admin>cmsh
switch>enable
switch#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)#cee-map default
switch(config)#end
3. Enter the copy command to save the running-config file to the startup-config file.
switch#copy running-config startup-config
Defining a priority group table
To define a priority group table map, perform the following steps from Privileged EXEC mode.
1. Enter global configuration mode.
switch#configure terminal
2. Specify the name of the CEE map to define. In this example ‘test’ is used.
switch(config)#cee-map default
3. Define the CEE map for PGID 0.
switch(config-ceemap)#priority-group-table 0 weight 50 pfc
4. Define the CEE map for PGID 1.
switch(config-ceemap)#priority-group-table 1 weight 50
5. Enter the copy command to save the running-config file to the startup-config file.
switch#copy running-config startup-config
3 15.4
4 15.3
5 15.2
6 15.1
7 15.0
TABLE 23 Default CEE priority table (Continued)
CoS PGID