Dell POWEREDGE M1000E - Manual (Page 139)

Dell Converged Enhanced Ethernet Administrator’s Guide 121
53-1002116-01
Deleting a Port Mirroring connection from a session
13
2. Configure the source port and the destination port, with the both parameter for all packets.
The destination port is always an external port.
switch(config-mon-sess-1)#source intengigabitethernet 0/1 destination
extengigabitethernet 0/18 direction both
3. Optional: Use the description command to add a label to the monitor session.
switch(config-mon-sess-1)#description Hello World!
4. Repeat step 1 and step 2 as needed for additional ports.
A monitor session can have only one port. For additional ports you must create additional
monitor sessions
Deleting a Port Mirroring connection from a session
To remove a single connection from a Port Mirroring session, perform the following steps in global
configuration mode.
1. Display the existing configuration of the monitor session.
switch#show monitor session 1
2. Open an existing monitor session.
switch(config)#monitor session 1
3. Use the no option to delete a particular port connection.
switch(config-mon-sess-1)#no source intengigabitethernet 0/1 destination
extengigabitethernet 0/18 direction both
4. Display the monitor session again to confirm the connection deletion.
switch#show monitor session 1
5. Repeat step 2 and step 3 as needed for additional ports.
A monitor session can have only one port.
Deleting a Port Mirroring session
To remove a Port Mirroring session, perform the following steps in global configuration mode.
1. Display the existing configuration of the monitor session.
switch#show monitor session 1
2. Enter global configuration mode with the enable command.
3. Delete the existing monitor session using the no option.
switch(config)#no monitor session 1
4. Return to Privileged EXEC mode with the exit command.
5. Display the monitor session again to confirm the connection deletion.
switch#show monitor session 1