Dell Studio 1435 (Late 2008) - Manual (Page 5)

4. During installation or removal of any hardware, always ensure all data is backed up properly.
5. Disconnect any external peripherals and cable.
6. Disconnect all telephone or network cables from the computer.
7. Press and eject any installed cards from the ExpressCard slot and the 8-in--1 memory card reader.
8. Disconnect your computer and all attached devices from their electrical outlets.
9. Turn the computer over.
10. Slide the battery release latch to the side.
11. Slide the battery out of the battery bay.
12. Press the power button to ground the system board.
Back to Contents Page
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you service the computer.
NOTICE: To avoid damage to the computer, use only the battery designed for this particular Dell computer. Do not use batteries designed for other Dell
computers.
1 battery 2 battery latch release