Dell 5350dn Mono Laser Printer - Manual (Page 160)

• Cancel the print job. Press the up or down arrow button until Cancel job appears, and then press .
Load Manual Feeder with <size>
Try one or more of the following:
• Load the multipurpose feeder with the correct paper size.
If there is no paper in the multipurpose feeder, then feed a sheet of paper to clear the message.
• Ignore the request and print on paper that is already being used in one of the input sources. Press the up or down
arrow button until Automatically select appears, and then press .
If the printer finds a source that has paper of the correct type, it uses the paper from that source. If the printer
cannot find a source with the correct paper type, it prints on the paper that is installed in the default paper source.
• Cancel the print job. Press the up or down arrow button until Cancel job appears, and then press .
Load Manual Feeder with <type> <size>
Try one or more of the following:
• Load the correct paper type and size in the multipurpose feeder.
• Ignore the request and print on paper that is already being used in one of the input sources. Press the up or down
arrow button until Automatically select appears, and then press . The current job may not print
correctly.
If the printer finds a source that has paper of the correct type, it uses the paper from that source. If the printer
cannot find a source with the correct paper type, it prints on the paper that is installed in the default paper source.
• Cancel the print job. Press the up or down arrow button until Cancel job appears, and then press .
Load staples
Try one or more of the following:
• Replace the specified staple cartridge in the finisher.
• Press the up or down arrow button until Continue appears, and then press to clear the message and
continue printing.
• Cancel the print job. Press the up or down arrow button until Cancel job appears, and then press .
Reattach bin <x>
Try one or more of the following:
• Turn the printer off and then back on.
If the error occurs a second time:
1 Turn the printer off.
2 Unplug the power cord from the wall outlet.
3 Remove the specified bin.
4 Reattach the bin.
Troubleshooting
160