I/o bracket, Removing the i/o bracket, Replacing the i/o bracket – Dell Inspiron Zino HD (400, Late 2009) User Manual
Page 22
Back to Contents Page
I/O Bracket
Dell™ Inspiron™ 300/400 Service Manual
Removing the I/O Bracket
1.
Follow the procedures in
Before You Begin
.
2.
Remove the top cover (see
Removing the Top Cover
).
3.
Remove the top bracket (see
Removing the Top Bracket
).
4.
Remove the I/O bezel (see
Removing the I/O Bezel
).
5.
Remove the chassis fan (see
Removing the Chassis Fan
).
6.
Using a hex nut driver, remove the two screws that secure the VGA connector to the I/O bracket.
7.
Remove the screw that secures the I/O bracket to the chassis.
8.
Carefully press and release the security lock latch on the I/O bracket out of the computer cover and lift the I/O bracket out of the computer.
Replacing the I/O Bracket
1.
Follow the procedures in
Before You Begin
.
2.
Slide the tabs on the bottom of the I/O bracket into the slots on the chassis.
3.
Carefully press and slide the security lock latch into place. Replace the screw that secures the I/O bracket to the chassis.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
screw
2
hex nut screws (2)
3
I/O bracket
4
security lock latch