Bottom cover, Removing the bottom cover, Replacing the bottom cover – Dell Inspiron Zino HD (400, Late 2009) User Manual
Page 4
Back to Contents Page
Bottom Cover
Dell™ Inspiron™ 300/400 Service Manual
Removing the Bottom Cover
1.
Follow the procedures in
Before You Begin
.
2.
Turn the computer over.
3.
Loosen the two captive screws that secure the bottom cover to the chassis.
4.
Lift the bottom cover off the computer base.
Replacing the Bottom Cover
1.
Follow the procedures in
Before You Begin
.
2.
Align the screw holes on the bottom cover with the screw holes on the chassis.
3.
Tighten the two captive screws that secure the bottom cover to the chassis.
4.
Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
captive screws (2)
2
bottom cover
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.