Dell Dimension 8400 - Manual (Page 28)

28
Setting Up and Using Your Computer
www
.dell.com | support.dell.com
To Remove Spare Marking From a Spare Hard Drive:
1 Right-click the spare hard drive icon.
2 Click Reset Hard Drive to Non-RAID
Rebuilding a Degraded RAID 1 Volume
If your computer does not have a spare hard drive, and the computer has reported a degraded RAID
1 volume, you can manually rebuild the computer’s redundancy mirror to a new hard drive by
performing the following steps:
1 Click the Start button and point to Programs → Intel(R) Application Accelerator → Intel
Application Accelerator to launch the Intel(R) Storage Utility.
2 Right-click the available hard drive to which you want to rebuild the RAID 1 volume, and
click Rebuild to this Disk.
3 You can use your computer while the computer is rebuilding the RAID 1 volume.
Setting Up a Home and Office Network
Connecting to a Network Adapter
NOTE:
Plug the network cable into the network adapter connector on the computer. Do not plug the
network cable into the modem connector on the computer. Do not plug a network cable into a telephone
wall jack.
1 Connect the network cable to the network adapter connector on the back of your computer.
Insert the cable until it clicks into place, and then gently pull it to ensure that it is secure.
2 Connect the other end of the network cable to a network device.
network device
network adapter connector on computer
network cable
network adapter
connector