Dell Dimension 8400 - Manual (Page 83)

Removing and Installing Parts
83
3 If you are installing a new card, remove the filler bracket to create a card-slot opening. Then
continue with step 5.
4 If you are replacing a card that is already installed in the computer, remove the card.
If necessary, disconnect any cables connected to the card. If your card includes a retention
mechanism, remove the top of the retention mechanism by pressing the tab and pulling up
on the top. Gently pull the securing tab, grasp the card by its top corners, and then ease it out
of its connector.
5 Prepare the card for installation.
See the documentation that came with the card for information on configuring the card,
making internal connections, or otherwise customizing it for your computer.
CAUTION:
Some network adapters automatically start the computer when they are connected to a
network. To guard against electrical shock, be sure to unplug your computer from its electrical outlet
before installing any cards.
6 If you are installing the card into the x16 card connector, position the card so the securing slot
is aligned with the securing tab, and gently pull the securing tab.
7 Place the card in the connector and press down firmly. Ensure that the card is fully seated in
the slot.
8 If you replaced a card that was already installed in the computer and you removed the top of
the retention mechanism, you may reinstall the top.
fully seated
card
not fully
seated card
bracket caught
outside of slot
bracket
within slot