Dell Dimension 8400 - Manual (Page 86)

86
Removing and Installing Parts
www
.dell.com | support.dell.com
10 If you removed a sound card:
a Enter system setup (see page 111), select Audio Controller, and then change the setting
to On.
b Connect external audio devices to the audio connectors on the back panel of the
computer.
11 If you removed an add-in network connector:
a Enter system setup (see page 111), select Network Controller, and then change the
setting to On.
b Connect the network cable to the integrated connector on the back panel of the
computer.
12 Install any drivers required for the card as described in the card documentation.
Card Fan
NOTICE:
PCI Express graphics card that run higher than 75 W require an additional cooling fan.
Otherwise, your card could overheat and damage your computer.
If a card fan is not present in your computer and you are installing a graphics card that runs at 75 W
or higher, contact Dell (see page 123) to find out how to purchase a card fan.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet
before opening the cover.
1 Follow the procedures in "Before You Begin" on page 59.
2 If spare drive rails are installed on the inside of the computer cover, remove them by gently
pulling the rails up and out.