Dell 2230d/dn Mono Laser Printer - Manual (Page 110)

Troubleshooting
Solving basic printer problems
If there are basic printer problems, or the printer is unresponsive, ensure the following:
• The power cord is plugged into the printer and a properly grounded electrical outlet.
• The electrical outlet is not turned off by any switch or breaker.
• The Ground Fault Circuit Interrupter (GFCI) has not tripped.
• The printer is not plugged into any surge protectors, uninterrupted power supplies, or extension cords.
• Other electronic equipment plugged into the outlet is working.
• The printer is turned on. Check the printer power switch.
• The printer cable is securely attached to the printer and the host computer, print server, or option.
• All options are properly installed.
• The printer driver settings are correct.
Once you have checked each of these possibilities, turn the printer off, wait for about 10 seconds, and then turn the
printer back on. This often fixes the problem.
Solving printing problems
Jobs do not print
Try one or more of the following:
V
ERIFY THAT THE PRINTER IS READY TO PRINT
Ensure that the light is on before sending a job to print.
C
HECK TO SEE IF THE STANDARD EXIT BIN IS FULL
Remove the stack of paper from the standard exit bin.
C
HECK TO SEE IF THE TRAY IS EMPTY
Load paper in the tray.
E
NSURE THAT YOU ARE USING A RECOMMENDED
USB
OR PARALLEL CABLE
For more information, contact Dell at support.dell.com.
E
NSURE THAT THE PRINTER CABLES ARE SECURELY CONNECTED
Check that the cables are firmly connected to the printer. For more information, see the setup documentation that
came with the printer.
Troubleshooting
110