Dell PowerVault DL2100 - Manual (Page 11)

Upgrading to BackupExec 2012
PowerVault DL Backup to Disk Appliance
Figure: Backup Exec Configure Options
12. Specify the service account and credentials for Backup Exec 2012 to use. This should be the same
service account specified for Backup Exec 12.5 or Backup Exec 2010. Select Next to continue.
13. Specify the location for the Backup Exec installation. It is recommended that you keep the default
location. Select Next to continue.
14. As part of the install, BackupExec 2012 will make a backup copy of the BackupExec 2010 settings found
on the system. Specify the location to store the backup settings. It is recommended that you keep the
default location. Select Next to continue.
15. Review the Backup Exec Installation Summary to verify your selections. Make sure to carefully review
any Warnings.