Canon LV-X4 LV-7230 - Manual (Page 13)

13
Part Names and Functions
This projector has eight different remote control codes (Code 1-Code 8); the factory-set, initial code (Code 1) and the other
seven codes (Code 2 to Code 8). This switching function prevents remote control interference when operating several
projectors or video equipment at the same time. (Change the remote control code for the projector first before changing
that for the remote control unit. See “Remote control” on page 44.)
While pressing the MENU button, press the IMAGE button
number of times corresponding to each remote control code
number. Each time you press the IMAGE button, the code is
changed sequentially. (See the list below.) 1
To initialize the remote control code for the remote control
unit, slide the RESET/ON/ALL-OFF switch to the RESET, and
then to the ON. The initial code is Code 1. 2
POINTER
While pressing the MENU
button, press the IMAGE
button number of times
corresponding to the remote
control code for the projector.
Remote Control Code
Number of Times of
Pressing IMAGE Button
Code 1 1
Code 2 2
Code 3 3
Code 4 4
Code 5 5
Code 6 6
Code 7 7
Code 8 8
MENU button
IMAGE button
INPUT
WA
RNING
LAMP REPLA
CE
MENU
PO WER
KEY ST
ONE
SET
VO L
VO L
+
-
Point the remote control unit toward the projector (Infrared
Remote Receiver) whenever pressing any button. Maximum
operating range for the remote control unit is about 16.4’
(5m) and 60° in front of the projector.
16.4’
(5 m)
60°
Operating Range
Remote Control Unit
at
a
e
s
a
d
u
c
t
o
s
Remote Control Code