Canon LV-X4 LV-7230 - Manual (Page 44)

44
Setting
Remote control
This projector provides eight different remote control codes (Code
1-Code 8);the factory-set, initial code(Code1) and the other seven
codes (Code 2 to Code 8). This switching function prevents
remote control interference when operating several projectors or
video equipment at the same time.
When operating the projector in “Code 7”, both the projector and
the remote control unit must be switched to “Code 7”.
To change the code for the projector;
Select either “Code 1” or “Code 8” in this Setting Menu.
To change the code for the remote control;
While holding down the MENU button, press the IMAGE button
number of times corresponding to the remote control code for
the projector. (See page 13 for details.)
Remote control
Lamp mode
This function allows you to change brightness of the screen.
Normal mode ···· normal brightness
Auto mode ···· the controlled brightness according with
input signal
Silent mode ···· lower brightness reduces the lamp power
consumption and extends the lamp life.
The sound is quiet.
USB
This projector is equipped with the USB port for interactive
operation between the projector and computer. Selects either of
the followings as needed.
···· When using the remote control unit as the wireless
mouse for a computer connected to the projector with
a USB cable.
···· When controlling the projector with a computer.
This item is provided for future use. Not available now.
✔
Note:
Lamp mode is not switched into Silent mode within 2 minutes after the projector is
turned on.
Select Spotlight or
Pointer with the Point
e
ed d button and press
the SET button. Then
select size or pattern
with the Point 7 8
button.
Pointer
You can emphasize a part of the projected image with this
function. Choose either Spotlight or Pointer with the Point ed
button and press the SET button. Then select one of three
different sizes (Large, Middle, and Small) of Spotlight or a pointer
of three different patterns (Arrow, Finger, and Dot) of Pointer.
(See page 12 for operation.)
Pointer
When pressing the SET button
at Remote Control Unit, the
remote control code menu
appears.