Canon LV-X4 LV-7230 - Manual (Page 46)

46
Setting
This function is used to reset the lamp replace counter. When
replacing the projection lamp, reset the lamp replace counter by
using this function. See page 51 for operation.
Lamp counter reset
Factory default
This function returns all setting values except for the PIN code
lock, the Logo PIN code lock, the User logo and the lamp counter
to the factory default settings.
Select Factory
default and this box
appears. Select
[Yes] , and the next
box appears.
Factory default
Select [Yes] to
activate it.
This function provides you the following alternatives in the cooling
fans operation after turning off the projector.
L1 . . . . . . . .normal operation. Cooling the projector for 90
seconds after turning off the projector.
L2 . . . . . .slower operation than the normal (L1) , but takes
longer to cool down the projector. Cooling the
projector for 120 seconds after turning off the
projector.
Fan Fan
The PIN code can be changed to your desired four-digit
number.
Select "PIN code change" with the Point
d d button, and press
the SET button. The New PIN code input dialog box will
appear.
Select a number with the Point 7 8 button and fix the number
with the SET button. Repeat it to complete entering a four-digit
number. When the four-digit number is fixed, the pointer will
automatically move to "Set". Then press the SET button.
Be sure to note the new Logo PIN code and keep it at hand.
To Change the PIN code
Select Off, On1, or On2 with the Point 7 8 button and then
"Quit" with the Point d d button and press the SET button to
close the dialog box.
To Change the PIN code lock setting
✔
Note:
If you forget your PIN code and unable to start operating the projector, the PIN code
can be reset to the factory default setting (1234) according to the following procedure
When you reset the PIN code, the Logo PIN code will be reset, as well.
1. Disconnect the AC Power Cord from the AC outlet.
2. As pressing the SET button on the projector, connect the AC Power Cord into an
AC outlet again. Keep pressing the SET button until the POWER indicator lights.
The PIN code will be returned to the factory default setting while the PIN code
lock state will remain the same as previous set state.
Change the PIN code
Select PIN code
change and press
the SET button. The
New PIN code input
dialog box will
appear.
The input numbers
are being displayed
for confirmation.
Change the PIN code lock setting
Select a desired
setting with the
Point 7 8 button.