Toner save mode, Power save mode, Charge-coupled device (ccd) power save mode – Dell 1815dn Multifunction Mono Laser Printer User Manual
Page 11
Toner Save Mode
The Toner Save mode enables your printer to use less toner on each page. Activating this mode extends the life of the toner cartridge longer than the normal
mode, but it reduces the print quality.
To turn the Toner Save mode on:
1.
Press Scroll (
or
) to highlight Menu and press Select (
).
2.
Press Scroll (
or
) to highlight Machine Setup and press Select (
).
3.
Press Scroll (
or
) to highlight Toner Save and press Select (
).
4.
Press Scroll (
or
) to highlight On and press Select (
).
5.
Press Cancel (
) to return to Standby mode.
Power Save Mode
The Power Save mode enables your printer to reduce power consumption when it is not in actual use. You can turn this mode on by selecting the length of
time for which the printer waits after a job is printed before it switches to a reduced power state.
1.
Press Scroll (
or
) to highlight Menu and press Select (
).
2.
Press Scroll (
or
) to highlight Machine Setup and press Select (
).
3.
Press Scroll (
or
) to highlight Power save and press Select (
).
4.
Press Scroll (
or
) to display On and press Select (
).
5.
Press Scroll(
or
) to display the time settings you want.
The available options are 5, 10, 15, 30, 60, and 120 (minutes).
6.
Press Select (
) to save the selection.
7.
Press Cancel (
) to return to Standby mode.
Charge-Coupled Device (CCD) Power Save Mode
The scan lamp under the document glass automatically turns off when it is not in actual use during a preset period to reduce power consumption and extend
the lamp life. The lamp automatically turns on and the warm-up cycle begins whenever any key is pressed or the document cover is opened or a document is
detected in the ADF.
You can set the length of time for which the scan lamp waits after a scan job is completed before it switches to the Power Save mode.
1.
Press Scroll (
or
) to highlight Menu and press Select (
).
2.
Press Scroll (
or
) to highlight Machine Setup and press Select (
).
3.
Press Scroll (
or
) to highlight CCD Power Save and press Select (
).
4.
Press Scroll (
or
) to display the time settings you want.
The available time options are 30, 60, and 120 (minutes).
5.
Press Select (
) to save the selection.
6.
Press Cancel (
) to return to Standby mode.
NOTE:
For PC-printing, you can also turn on or off the Toner Save mode in the printer properties. See
"Graphics Tab"
.