Dell diagnostics, When to use the dell diagnostics, Agnostics (see "dell diagnostics" on – Dell Precision T5400 (Late 2007) User Manual
Page 136: The "dell, See "dell diagnostics, Dell, Diagnostics (see "dell diagnostics" on, Ee "dell diagnostics" on, Ee "dell diagnostics
136
Troubleshooting Tools
Dell Diagnostics
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the
Product Information Guide.
When to Use the Dell Diagnostics
If you experience a problem with your computer, perform the checks in
"Lockups and Software Problems" on page 112 and run the Dell Diagnostics
before you contact Dell for technical assistance.
It is recommended that you print these procedures before you begin.
NOTICE:
The Dell Diagnostics works only on Dell™ computers.
NOTE:
The Drivers and Utilities disc is optional and may not ship with your
computer.
Enter system setup (see "System Setup" on page 89), review your computer’s
configuration information, and ensure that the device you want to test
displays in system setup and is active.
U
NEXPECTED
INTERRUPT
IN
PROTECTED
MODE
— Run the Dell Diagnostics (see "Dell
WARNING: D
ELL
'
S
D
ISK
M
ONITORING
S
YSTEM
HAS
DETECTED
THAT
DRIVE
[0/1]
ON
THE
IDE
CONTROLLER
IS
OPERATING
OUTSIDE
OF
NORMAL
SPECIFICATIONS
. I
T
IS
ADVISABLE
TO
IMMEDIATELY
BACK
UP
YOUR
DATA
AND
REPLACE
YOUR
HARD
DRIVE
BY
CALLING
YOUR
SUPPORT
DESK
OR
D
ELL
— If no replacement drive is immediately available and the drive is not
the only bootable drive, enter system setup (see "System Setup" on page 89) and
change the appropriate drive setting to None. Then remove the drive from the
computer.
W
RITE
FAULT
—
W
RITE
FAULT
ON
SELECTED
DRIVE
—
See "Drive Problems" on page 107.
<drive letter>:\
IS
NOT
ACCESSIBLE
. T
HE
DEVICE
IS
NOT
READY
— The floppy drive cannot
read the disk. Insert a floppy disk into the drive and try again.