Dell Precision T5400 (Late 2007) User Manual
Page 213
Adding and Replacing Parts
213
3 Remove the computer cover (see "Removing the Computer Cover" on
NOTICE:
If only one hard drive is to be installed
, it should be connected to the
SATA0 connector on the system board.
4 Disconnect the hard drive power cable from the hard drive that you are
removing.
5 Disconnect the data cable from the hard drive that you are removing.
Do not disconnect the data cable for an uninstalled hard drive from the
system board.
6 Rotate the hard-drive carrier out of the computer (see "Rotating the Hard-
Drive Carrier Back into the Computer" on page 159).
7 Press the blue tabs on each side of the hard-drive bracket toward each
other and slide the drive up and out of the hard-drive bay.
1
data connector
2
power connector
3
hard drive
3
1
2