Dell Precision 670 - Manual (Page 92)

Removing and Replacing Parts: Dell Precision Workstation 470 and 670 Computers User's Guide
file:///T|/htdocs/systems/ws670/EN/ug_en/before.htm[3/20/2013 9:31:52 AM]
3. Attach the power and floppy-drive cables to the floppy drive.
1 power cable
2 floppy-drive cable
3 system board connector
4. If you are installing a new floppy drive rather than replacing a drive, remove the front-panel inserts.
From inside the drive bay, gently press on each side of the insert until it pops out.
5. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
6. Close the computer cover .
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
7. Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
8. Enter system setup and update the appropriate Diskette Drive A option to reflect the size and capacity of your new
floppy drive.
9. To verify that your computer works correctly, run the Dell Diagnostics .
CD/DVD Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.