Dell PowerEdge M605 - Manual (Page 145)

Installing Blade Components
145
Figure 3-25. Removing and Installing a Hard Drive In a Drive Carrier
Video Controller
Follow these steps to replace the video controller.
1 Remove the blade. See "Removing a Blade" on page 96.
2 Open the blade. See "Opening the Blade" on page 100.
3 Remove the video controller:
• If you are removing the video controller from a PowerEdge M600, press
the latch on the upper edge of the video riser card, then lift the card
from the blade. See Figure 3-26.
• If you are removing the video controller from a PowerEdge M605, M805,
or M905, remove the two torx screws securing the daughter card, then
lift the card from the blade. See Figure 3-27.
1 hard drive 2 drive carrier
3 screws (4)
1
2
3