Dell PowerEdge M605 - Manual (Page 44)

44
About Your System
• Slot Mezz2_Fabric_B and slot Mezz4_Fabric_B support Fabric B. If a card
is installed in both slots, both cards must be identical. They must also
match the fabric type of the I/O modules installed in I/O module bays B1
and B2.
PowerEdge M600 and M605
The half-height PowerEdge M600 and M605 blades support two mezzanine
cards:
• Mezzanine card slot C supports Fabric C. This card must match the fabric
type of I/O modules installed in I/O module bays C1 and C2.
• Mezzanine card slot B supports Fabric B. This card must match the fabric
type of I/O modules installed in I/O module bays B1 and B2.
See "I/O Module Mezzanine Cards" on page 123 for more information on
mezzanine cards.
Table 1-11 shows various supported combinations of mezzanine cards and I/O
modules.
Table 1-11. Supported I/O Module Configurations
Fabric A Fabric B
Mezzanine
Card Fabric C
Mezzanine
Card I/O Bay A1,
A2 I/O Bay B1,
B2 I/O Bay C1,
C2
Standard
Integrated
LOM NIC none none Ethernet
switch
module or
pass-through
module none none
Standard
Integrated
LOM NIC Ethernet
mezzanine
card none Ethernet
switch
module or
pass-through
module Ethernet
switch
module or
pass-through
module none
Standard
Integrated
LOM NIC none Infiniband
mezzanine
card Ethernet
switch
module or
pass-through
module none Infiniband
switch
module