Dell PowerEdge M605 - Manual (Page 172)

172
Installing Enclosure Components
Figure 4-9. Removing and Installing the Midplane
Installing the Midplane and Front Module Cage Assembly
CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Attach the midplane to the front module cage assembly and secure it with
the four Torx screws. See Figure 4-8.
2 Connect the control-panel cable to the midplane.
3 Carefully slide the front module cage assembly into the enclosure. See
Figure 4-9.
4 Install the four screws to secure the front module cage assembly.
5 Install the I/O modules. See "Installing an I/O Module" on page 167.
1 front module cage assembly 2 midplane
3 screws (4)
1
2
3