Figure 1-5, Figure 1-5, both, Figure 1-5 with – Dell PowerVault NX1950 User Manual
Page 16
16
Introduction
Figure 1-5. Non-Redundant iSCSI Paths Using Four NICs
• For more information about the pre-requisites to configure the PowerVault
NX1950 cluster solution as an iSCSI Target, see the section
Creating a
Highly Available iSCSI Target in Dell PowerVault NX1950 Cluster Systems
Installation and Troubleshooting Guide on the Dell Support website at
support.dell.com.
NOTE:
Before you configure the PowerVault NX1950 cluster solution as an
iSCSI Target, turn off the firewall in all cluster nodes to ensure proper iSCSI
Target configuration.
For more information about PowerVault NX1950 storage solutions, see the
Dell PowerVault NX1950 Systems Support Matrix located at the Dell
Support website at
support.dell.com.
public network
host
(Initiator
PowerVault NX1950 storage system
with NIC teaming (cluster node)
PowerVault NX1950 storage system
with NIC teaming (cluster node)
host
(Initiator
teamed NICs
for public
network
iSCSI network
heartbeat
network
switch
NIC teaming