Dell PowerVault NX1950 - Manual (Page 25)

Quick Install Steps for Initiator-Target Connection 25
Pre-Requisites
Before you perform iSCSI Target discovery, perform the following steps:
1 Download the Microsoft iSCSI Initiator software from Microsoft Support
website at support.microsoft.com and install the Initiator (Host).
2 Download the Microsoft iSNS Server software from Microsoft Support
website at support.microsoft.com and install the software on a
client/server running Microsoft ® Windows ® operating system.
NOTE: Do not install the iSNS Server software on Initiator (host) or Target
(PowerVault NX1950 storage solution). Install the software on a separate
Client/Server running Windows operating system.
3 Turn on the PowerVault NX1950 storage system and the PowerVault
MD3000 storage array or Dell|EMC storage array configured with the
storage system. Create one or more volumes on the storage array for
creating Virtual Disks for iSCSI Targets.
Configuring Settings From the Initiator Server/Client
1 Configure the Microsoft iSCSI Initiator with iSNS server's information.
Go to Start→ Programs→ Microsoft iSCSI Initiator→ Discovery tab→ Add.
2 Add the IP address of the iSNS server and click OK.
Setting Up the Target (PowerVault NX1950 Storage Solution and
PowerVault NX1950 Cluster Solution)
1 From the PowerVault NX1950 storage solution, go to Start→ Programs→
Administrative Tools→ Windows Unified Data Storage Server.
The
PowerVault NX1950 Management Console appears.
2 Select Microsoft iSCSI Software Target, right-click and select Properties.
3 In the Properties window, select the iSNS tab, and add the iSNS server
information (DNS Name or IP address).
NOTE: If you are configuring a PowerVault NX1950 cluster solution, add the
iSNS server information in the node that owns the Cluster Group. In all other
cluster nodes, go to the PowerVault NX1950 Management Console ensure
that iSNS tab is populated with the iSNS server information.