Dell PowerVault NX1950 - Manual (Page 38)

38 Detailed End-to-End iSCSI Setup
7 Perform the following steps to create iSCSI Targets:
Figure 3-4. Creating iSCSI Targets
NOTE: In the PowerVault NX1950 Management Console, right-click Microsoft
iSCSI Software Target, and select Properties. In the Networks tab, select the
corresponding iSCSI NIC IP address and deselect the remaining IP addresses.
If you are using the 3.1 iSCSI Target, select the highly available iSCSI instance
IP address only.
a In the PowerVault NX1950 Management Console, right-click iSCSI
Targets on the left pane to launch the Create iSCSI Target Wizard.
b The Welcome to the Create iSCSI Target Wizard screen appears.
Click Next.
c The iSCSI Target identification screen appears. Enter the Target
name and Description. You can use the Browse option to view and
choose the servers/clients in the network.
d The iSCSI initiators identifiers screen appears.
You must associate each iSCSI Target with an iSCSI Initiator.
The iSCSI Initiator is the host that requests access to the storage that
is represented by the iSCSI Target name.