Dell PowerVault 770N (Deskside NAS Appliance) - Manual (Page 58)

Cabling a SAN-Attached Cluster to the CX600 Storage System
1. Connect cluster node 1 to the SAN.
a. Connect a cable from HBA0 to Fibre Channel switch 0 (sw0).
b. Connect a cable from HBA1 to Fibre Channel switch 1 (sw1).
2. Repeat step 1 for each node.
3. Connect the storage system to the SAN.
a. Connect a cable from Fibre Channel switch 0 (sw0) to SP-A port 0.
b. Connect a cable from Fibre Channel switch 0 (sw0) to SP-A port 2.
c. Connect a cable from Fibre Channel switch 0 (sw0) to SP-B port 1.
d. Connect a cable from Fibre Channel switch 0 (sw0) to SP-B port 3.
e. Connect a cable from Fibre Channel switch 1 (sw1) to SP-A port 1.
f. Connect a cable from Fibre Channel switch 1 (sw1) to SP-A port 3.
g. Connect a cable from Fibre Channel switch 1 (sw1) to SP-B port 0.
h. Connect a cable from Fibre Channel switch 1 (sw1) to SP-B port 2.
Figure 5-5. Cabling a SAN-Attached Cluster to the CX600 SPE