Step 1, Step 2 – Dell PowerVault 770N (Deskside NAS Appliance) User Manual
Page 60
b. Connect a cable from Fibre Channel switch 0 (sw0) to SP-B port FE A.
Cabling Multiple SAN-Attached Clusters to the CX400 Storage System
1. In the first cluster, connect cluster node 1 to the SAN.
a. Connect a cable from HBA0 to Fibre Channel switch 0 (sw0).
b. Connect a cable from HBA1 to Fibre Channel switch 1 (sw1).
2. In the first cluster, repeat
3. For each additional cluster, repeat
4. Connect the storage system to the SAN.
a. Connect a cable from Fibre Channel switch 0 (sw0) to SP-A port FE 0.
b. Connect a cable from Fibre Channel switch 0 (sw0) to SP-B port FE 1.
c. Connect a cable from Fibre Channel switch 1 (sw1) to SP-A port FE 1.
d. Connect a cable from Fibre Channel switch 0 (sw1) to SP-B port FE 0.
Cabling Multiple SAN-Attached Clusters to the CX600 Storage System
1. In the first cluster, connect cluster node 1 to the SAN.
a. Connect a cable from HBA0 to Fibre Channel switch 0 (sw0).
b. Connect a cable from HBA1 to Fibre Channel switch 1 (sw1).
2. In the first cluster, repeat
3. For each additional cluster, repeat
4. Connect the storage system to the SAN.
a. Connect a cable from Fibre Channel switch 0 (sw0) to SP-A port 0.
b. Connect a cable from Fibre Channel switch 0 (sw0) to SP-A port 2.
c. Connect a cable from Fibre Channel switch 0 (sw0) to SP-B port 1.
d. Connect a cable from Fibre Channel switch 0 (sw0) to SP-B port 3.
e. Connect a cable from Fibre Channel switch 1 (sw1) to SP-A port 1.
f. Connect a cable from Fibre Channel switch 1 (sw1) to SP-A port 3.
g. Connect a cable from Fibre Channel switch 1 (sw1) to SP-B port 0.
h. Connect a cable from Fibre Channel switch 1 (sw1) to SP-B port 2.
Zoning Your Dell | EMC Storage System in a Switched Environment
Dell only supports single-initiator zoning for connecting NAS clusters to a Dell | EMC storage system in a switched
environment. When using EMC PowerPath, a separate zone is created from each HBA to the following hardware components: