Dell OptiPlex Gxi - Manual (Page 98)

7-12 Dell OptiPlex GXi Low-Profile Systems Reference and Installation Guide
then press the cable connector firmly onto the
adapter card connector.
• If you are installing an external SCSI device,
connect the other end of the external SCSI cable
to the external connector on the host adapter
card.
For additional instructions, see the documentation
that came with the adapter card.
8. Connect the SCSI device(s) to power.
• If you are installing an internal SCSI device,
connect a DC power cable to the power input
connector on the SCSI device.
• If you are installing an external SCSI device,
connect the socket end of the power cable into
the AC power receptacle on the back of the
SCSI device. Connect the other end of the
power cable into a standard electrical wall
outlet.
Check all other cable connections. Fold all internal
cables out of the way to provide airflow for the fan
or cooling vents.
If you are installing a SCSI hard-disk drive, replace
the expansion-card cage according to the instructions
provided in “Replacing the Expansion-Card Cage”
in Chapter 5.
9. Replace the computer cover. Then reconnect your
computer and peripherals to their power sources,
and turn them on.
10. If necessary, enter the System Setup program to
update the system configuration information.
If you installed a SCSI hard-disk drive, set the
DRIVE 0 and DRIVE 1 System Setup categories under
DRIVES: PRIMARY to NONE . For instructions, see
Chapter 2, “Using the System Setup Program.”
Tape drives attached to a SCSI host adapter card are
not part of the system configuration information.
11. If you installed a SCSI hard-disk drive, partition
and format the drive. Then install the operating
system.
For instructions, see the next subsection, “Partition-
ing and Formatting SCSI Hard-Disk Drives,” and
your operating system documentation.
12. Test the SCSI devices.
Test a SCSI hard-disk drive by running the SCSI
Devices Test Group of the Dell diagnostics.
See your Diagnostics and Troubleshooting Guide for
information on running the diskette-based diagnos-
tics and troubleshooting any problems that may
occur.
To test a SCSI tape drive, refer to the documentation
for the tape drive software to perform a tape drive
backup and verification test.
Partitioning and Formatting SCSI
Hard-Disk Drives
You may need to use different programs than those pro-
vided with the operating system to partition and format
SCSI hard-disk drives. Refer to the documentation that
came with your SCSI software drivers for information on
installing the appropriate drivers and preparing your
SCSI hard-disk drive for use.
NOTE: On systems with hard-disk drives larger than
2 GB, create a primary partition of 2 GB and divide the
remaining capacity into partitions of 2 GB or less. For
example, a system with a 2.5-GB hard-disk drive would
have a primary partition of 2 GB (drive C) and a second
partition of 500 MB (drive D). Hard-disk drives must be
partitioned this way because MS-DOS–based operating
systems (including Windows NT when using a FAT16 file
system) do not support drive partitions larger than 2 GB.
CAUTION: You must match the colored
strip on the internal SCSI cable with pin 1
on the adapter card connector to avoid
possible damage to your system.