Dell Dimension 4100 - Manual (Page 14)

14 Setting Up
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
Then follow the instructions that came with the printer to connect it to the
computer. If no information is provided, see the following sections.
Parallel Printer
1 Turn off the computer (see page 16).
NOTICE: Use only a standard IEEE parallel cable measuring 3 m (10 ft) or
less to connect the printer to the computer. Use of a nonstandard cable may
prevent the printer from working.
2 Attach the parallel printer cable to the parallel connector on the
computer and tighten the two screws. Attach the cable to the parallel
connector on the printer and snap the two clips into the two notches.
3 Turn on the printer and then turn on the computer. If the Add New
Hardware Wizard window appears, click Cancel.
4 Install the printer driver if necessary (see page 15).
notches (2)
parallel printer
cable
screws (2)
parallel
connector on
printer
parallel connector on
computer
clips (2)