Dell Dimension 4100 - Manual (Page 50)

50 Adding Parts
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m 7 Replace the computer cover (see page 71).
NOTICE: To connect a network cable, first plug the cable in to the network
jack and then plug it in to the computer.
8 Plug your computer and devices into their electrical outlets, and turn
them on.
Adding a Second Hard Drive
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 7.
Your computer includes one hard drive. To add a second hard drive, perform
the following steps.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network jack.
1 Turn off the computer and devices, and disconnect them from their
electrical outlets.
2 Briefly press the power button.
Pressing the power button when the computer is not connected to an
electrical outlet discharges residual electricity and can help prevent
system board damage.
3 Remove the computer cover (see page 42).