Dell PowerEdge SC1425 - Manual (Page 10)

Back to Contents Page
Service-Only Parts Replacement Procedures
Dell™ PowerEdge™ SC1425 Systems Installation and Troubleshooting Guide
Recommended Tools
Control Panel Assembly
System Board
Recommended Tools
You may need the following items to perform the procedures in this section:
l Key to the system keylock
l Wrist grounding strap
l #2 Phillips screwdriver
Control Panel Assembly
Removing the Control Panel Assembly
1. Open the system. See " Opening the System " in "Troubleshooting Your System."
2. Disconnect the control panel cables. See Figure C -1 .
3. Using a #2 Phillips screwdriver, remove the two screws that secure the control panel assembly to the chassis. See Figure C -1 .
4. Carefully lift the back of the control panel assembly to clear the chassis mounting studs, and remove the assembly from the system.
Figure C-1. Control Panel Assembly Removal
Installing the Control Panel Assembly
1. Align the control panel assembly's mounting holes with the chassis mounting studs, and lower the assembly over the studs. See Figure C -1 .
2. Using a #2 Phillips screwdriver, install the two screws that secure the control panel assembly to the chassis. See Figure C -1 .
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as
authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not
authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as
authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not
authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.