Install a hard drive, Remove the hard drive, Remove the hard – Dell Latitude D500 User Manual
Page 41: Drive, Replacing the hard drive
Replacing the Hard Drive
NOTICE:
To prevent data loss, shut down your computer before removing the hard drive. Do not remove the hard
drive while the computer is on, in
, or in
NOTICE:
Hard drives are extremely fragile; even a slight bump can damage the drive.
CAUTION:
If you remove the hard drive from the computer when the drive is hot, do not touch the metal
housing of the hard drive.
CAUTION:
Before working inside your computer, read the safety instructions in your System Information
Guide.
NOTE:
Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
1. Ensure that the work surface is flat and clean to prevent scratching the computer cover.
2. Save and close any open files, exit any open programs, and shut down the computer.
3. If the computer is connected to a docking device (docked), undock it. See the documentation that came with your
docking device for instructions.
4. Remove all installed batteries, and disconnect the AC adapter cable and any external devices from the computer. Wait
5 seconds before proceeding.
5. Ground yourself by touching a metal connector on the back of the computer, and continue to do so periodically during
this procedure.
6. Turn the computer over. Use a small screwdriver to loosen the captive hard drive screw.
1
captive screw
7. Turn the computer over so that it is upright.
NOTICE:
You cannot remove your hard drive unless you open your display first.
8. Open the display approximately 2.54 cm (1 in).